Steroid injections can be used to treat some problems in the arm and hand. These can include trigger fingers, tendonitis, carpal tunnel syndrome, arthritis, tennis elbow and rotator cuff tendonitis. These injections usually contain cortisone and a numbing medicine.
Cortisone is a steroid normally produced by your body, and it is a powerful anti-inflammatory. Corticosteroids tend to shrink, thin and slow things down. These steroids are different from anabolic steroids, which have been abused by athletes to build muscle and enhance performance.
Injectable steroids are in 2 forms, oil-based and water-based. Generally, those injectable steroids that are oil-based have longer and better half-life than water-based steroids. Both, of them, have much longer half-lives than oral steroids. And because of this drawback, injectable steroids have high probability of being observed in drug screening since their clearance times are longer than on oral steroids. Bodybuilders resolve this issue by using injectable steroids early in an injectable cycle and after switch to an oral cycle when approaching the end of the cycle and drug testing is imminent.
Injectable steroids are those that you must inject subcutaneously or intramuscularly. For the most part, they require less frequent dosing than their oral counterparts do, though this depends primarily on the steroid’s half-life. Some popular examples of injectable steroids include Trenbolone, Deca Durabolin, and Winstrol, to name a few. Although injectable steroids are not as hepatotoxic as oral steroids are, they can still present some risks. Side effects vary based on the exact compound. Expert users all agree that injectable steroids are best for higher quality gains over time and there is nothing at all like them when it comes to cutting cycles.
Before injecting an anabolic steroid into your body, there are many things to consider. You should have proper knowledge or proper supplies and maintain proper sterility. When you ignore the procedure or do not prepare adequately, it can lead to inflammation, infections, abscesses, scar tissue development, muscle damage, nerve damage, and even fatality.
Proper sterility should be maintained, for example, you should never re-use pins, share them with others, or try to sterilize them by rubbing them with alcohol or exposing them to flame. Dangerous diseases can be transmitted like this. Proper procedures should be followed and utmost safety should be maintained. Here are a few pre-injection tips.
The common use of injectable steroids among athletes and Their seeming preference for them seems is related to the life of the injectable steroid. The injection lasts longer and some claim that injectable anabolic steroids also do not have the side effects that 17 alpha alkylation type to steroids. Some claim that injections site where they want to “pump” up are effective. There does not seem to be any clinical support for that though.
Testosterone is usually given as an injection since it metabolizes poorly otherwise. Aside from the issues presented by untrained persons, performing a medical procedure that requires at least a little training, and consideration for injectable steroids is that they tend to stay longer in the body and the side effects from anabolic steroids can last a lifetime unlike the career or the muscles.
Injectable anabolic steroid preparations include active substances, which are released in the form of oily solutions or aqueous suspension.
Such drugs have high anabolic and androgenic activity and are widely used in weightlifting, triathlon, bodybuilding, bodyfitness and other sports. The purpose of such courses is intensive set of muscle mass, drying and relief, increasing strength and stamina.
ANABOLIC: OILY SOLUTIONS OR AQUEOUS SUSPENSION
The oily solution differs from the aqueous suspension in that it has a uniform consistency, it does not have a precipitate. The aqueous suspension consists of very small particles (suspended matter) that do not dissolve in water, but can be stirred when they are shaken.
In general, anabolic steroids are produced on the basis of oil. The exception to the rules is Stanozolol and Aquatest, which are aqueous suspensions. Also now, the aqueous suspension of Trenbolone (Androxine from Alfa Pharma) appeared on the market of sports pharmacology, which is an alternative to trenbolone in the form of an oil solution.
IS IT POSSIBLE TO MIX SEVERAL STEROIDS IN ONE SYRINGE?
Often, athletes who use several injections in their course want to reduce the soreness of injections and reduce the number of injections and holes in the ass. Therefore, the actual question is how to mix injectable steroids without the risk of cones, abscesses and other unpleasant complications.
To date, pharmacological companies produce steroids dissolved in oil or water. Oily preparations are a homogeneous mass in which there is no sediment and suspensions. In turn, aqueous suspensions are a suspension of fine particles of the active component AAS in water. In this case, they can not completely dissolve, but only mix.
Since we know from the school that the oil can not dissolve in water, as it is easier for it, it is possible to mix only oil-based anabolics with similar ones. With water preparations they can not be interfered.
Rule number 1. Oil solutions can be mixed only with oil solutions.
Rule No. 2. Aqueous suspensions can only be mixed with aqueous suspensions.
For example: Stanozolol in injections can be combined in one syringe with Aquatest – an aqueous suspension of Testosterone; Testosterone in oil solution (propionate, enanthate, cypionate) can be pricked together with Nandrolone, etc.
Which steroids to choose: in tablets or in injections?
Beginners usually try to use only anabolics in tablets, rather than injections, avoiding injections for various reasons – to be afraid of painful injections, do not want to give injections because of the inconvenience of the application (there is no one to put the injections, and he does not know how), or is experiencing on possible reactions in the form of the appearance of swelling, cones, abscesses, etc.
But over time, when the objectives of the courses increase, it becomes necessary to use combined courses that combine both steroids in tablets and steroids in injections. It must also be taken into account that many highly effective, indispensable drugs with a high anabolic index in tablets simply do not exist. This, for example, Trenbolon, Boldenon, Nandrolone.
Among other things, anabolic steroids in injections do not have toxic effects on the liver and are safer than the drugs produced in tablets.
How many times a week do I need to inject anabolic steroids?
1. Water suspensions are pricked every day.
2. Anabolic injections based on oily solutions are made, depending on the type of ether. If it is propionate, isocaproate, then injections need to be done every other day. In the case of esters with a long half-life (enanthate, decanoate, cypionate), injections should be given 2 times a week.
HOW TO MAKE INJECTIONS CORRECTLY?
Using injectable AAS requires certain skills and knowledge from athletes. It is for this reason that beginners prefer tablets. Learn how to make injections correctly.
To successfully carry out a cycle of steroids using injectable anabolics, certain manipulations must be performed correctly. The most important points in the introduction of drugs is the correct location of the injection site, the choice of the syringe, the preparation of the steroid itself for use and strict adherence to the elementary rules of hygiene. Let’s see how to make injections correctly.
Where to stab AAS
When using all steroid drugs, regardless of the base (oil or water) are administered intramuscularly. In simple terms, you need to pierce the skin with a needle, the tissues located under it and insert a steroid inside the muscle. Most often, three parts of the body are used for this: the buttocks, deltas and the lateral surface of the thigh.
Since it is here that a large number of fibers are located, and the area of the connective tissue membrane (connective tissue that separates the muscles from each other and covers them) is large enough, the drug after the injection has excellent chances to spread rapidly throughout the muscle tissue. The optimal place for the introduction of steroids will be the place where there are no large nerve fibers and blood vessels.
This place is the upper outer quarter of the buttocks. Orientation for its location can serve as a crest of the ilium, which is easy to grope just above the middle of the gluteal muscles. This is a very massive area and it practically lacks nerve fibers and large capillaries.
Also, with the introduction of drugs in this area, there is practically no possibility of damaging the sciatic nerve, which crosses the lower and middle parts of the gluteal muscles. This is a very important nerve, since it is he who is responsible for the work of the foot. If you accidentally touch it with the introduction of anabolic, then there is a strong pain sensation, and this part of the body will be paralyzed for a while.
No less important issue when using injectable AAS is the proper selection of a syringe. The most optimal is the use of syringes with a capacity of four milliliters and a needle diameter of 0.6-0.7 millimeters. In this case, their length should be 4.8 or 2.5 centimeters. Shorter needles can not penetrate deeply, and the solution does not fall into muscle tissue.
How to correctly administer the drug
Before the injection, you should thoroughly wash your hands, and then rub alcohol with the place of the alleged injection. It is also necessary to similarly process the rubber cap of the vial through which the needle passes for a steroid kit into the syringe.
Remove the plastic cap from the disposable syringe and draw air into it. After breaking the vial cap, let the air inside. This is necessary in order to increase the pressure inside, which will greatly facilitate the collection of the oil steroid. Turn the bottle upside down and start to slowly gain a little more than the required amount of the drug, about a quarter of a cubic centimeter.
For example, when you need to enter one anabolic cube, you need to get a quarter more cube into the syringe. After this, it is necessary to slightly tap on the syringe with your finger, so that all the air is lifted up. After this, the excess of the steroid is reintroduced into the vial, so that the amount of AAS necessary for the injection remains in the syringe.
Taking the needle from the bottle, tap on the syringe again. You should also change the needle to get the most sharpness. Wipe the site of the injection with alcohol and squeeze out the syringe air. Do this until the first drop of the drug appears. It must drain on the needle to give it extra lubrication.
It’s time for the introduction of the steroid. Use the syringe as if holding a dart ready for throwing. With the second hand, stretch the puncture site and insert the needle with a sharp movement. Begin slowly squeeze the drug. When the syringe is emptied, gently pull the piston upward to ensure that the capillary has not been penetrated. After that, quickly remove the needle and strongly push the injection site with a cotton swab dipped in alcohol. It is very important to pay attention to the fact that the drug must be administered slowly in order to reduce pain.
How to properly prick in the buttock and thigh
When the drug is injected into the thigh, you should select the middle part of the outer surface for this. Mentally divide this section into three equal parts. For injection, only the average is suitable. It is also important to remember that in the thigh the prick can be placed only in the sitting position.
When you introduce AAS into the buttock, you need to mentally divide it into four equal parts. The injection should be placed in the upper outer part. Before the introduction of the steroid, you should transfer the weight of the body to the second leg, in order to relax the muscles at the site of the future puncture. Then everything is done as described in the previous paragraph.
What to do if the blood vessel is damaged
If you still hurt the capillary, then actually do not do anything already and do not. Although on the recommendation of health professionals need to get a needle and inject the drug elsewhere. But if you do not, and continue to enter the steroid, then nothing terrible will happen. At the puncture site, then a bruise is formed, which soon will resolve.
[ 10ml vial (300mg/ml) ] $107.00
[ 10 ampoules (200mg/ml) ] $54.00
[ 10 ampoules (250mg/ml) ] $43.00
[ 10ml vial (400mg/ml) ] $65.00
Human Chorionic Gonadotropin
[ 1 vial of 5000IU ]
[ 10 ampoules (100mg/ml) ] $96.00
[ 10 ampoules (100mg/ml) ] $29.00
[ 10 Ampoules (50mg/ml) ] $38.00
[ 10 ampoules (250mg/ml) ] $45.00
[ 10 ampoules (100mg/ml) ] $65.00
[ 10ml vial (250mg/ml) ] $55.00